Multi-frequency GNSS is the reception of signals from the same navigation satellites on more than one carrier frequency, so that a receiver can combine the observables and reduce or estimate frequency-dependent effects such as ionospheric delay.12

First-order ionospheric effects on code and carrier-phase measurements depend on the inverse square of the signal frequency. A dual-frequency receiver can form a linear combination of code or carrier measurements in which that first-order term is eliminated.12 Navipedia presents this as removal of the first-order effect only, so higher-order ionospheric terms, multipath and receiver noise are not covered by the combination.1

Other combinations of the same observables serve different purposes. A geometry-free combination leaves the frequency-dependent effects and can be used to estimate ionospheric electron content or detect cycle slips, and a wide-lane combination creates a signal of long effective wavelength that helps with cycle-slip detection and ambiguity fixing.1

On the signal side, the GPS programme describes new civil signals at L2C, L5 and L1C being fielded alongside the legacy L1 C/A signal, and states that a dual-frequency receiver using L1 C/A with L2C can apply ionospheric correction. It also states that users must upgrade their equipment to benefit.3 The sources do not give current satellite counts or a general definition of the term, and the examples are dual-frequency; the same reasoning is not shown here for three or more frequencies.13

Footnotes

  1. ESA Navipedia, “Combination of GNSS Measurements”, 2011. https://gssc.esa.int/navipedia/index.php/Combination_of_GNSS_Measurements ↩ ↩2 ↩3 ↩4 ↩5

  2. ESA Navipedia, “Ionosphere-free Combination for Dual Frequency Receivers”, 2011. https://gssc.esa.int/navipedia/index.php/Ionosphere-free_Combination_for_Dual_Frequency_Receivers ↩ ↩2

  3. GPS.gov, “New Civil Signals”. https://www.gps.gov/new-civil-signals ↩ ↩2