GNSS jamming is intentional radio frequency interference that prevents a GNSS receiver from locking onto satellite signals, leaving its position and time service degraded or unusable.12

GNSS signals arrive at the receiver with very low power, so a transmitter on the same frequencies can overwhelm them. One research paper describes jamming as the transmission of a high-powered signal towards the target device to disrupt its communication with the satellites, and separates it from unintentional interference such as that from communication or television transmitters.2

Jamming differs from spoofing. Under jamming the receiver typically loses or degrades its solution, whereas spoofing supplies counterfeit signals that can lead to a plausible but wrong one. The same paper reports that in jamming both the automatic gain control and carrier-to-noise indicators fall, while in the spoofing cases it discusses the carrier-to-noise value can stay relatively constant. That is a finding of the cited research, not a general detection rule.2

EASA describes interference as able to occur in any phase of flight, leading to re-routing or diversions. Its recommendations for suspected jamming include verifying aircraft position by non-GNSS means and reporting irregularities. The bulletin behind that page was in its fourth revision when retrieved, and neither source gives a general figure for the range or power at which a jammer defeats a given receiver.1

Footnotes

  1. EASA, “Global Navigation Satellite System (GNSS) Outages and Alterations”, page summarising Safety Information Bulletin 2022-02R4. https://www.easa.europa.eu/en/domains/air-operations/global-navigation-satellite-system-outages-and-alterations ↩ ↩2

  2. Nabi et al., “Using machine learning for the detection of structured interference in Global Navigation Satellite Systems”, PeerJ Computer Science 10:e2399, 2024. https://www.ncbi.nlm.nih.gov/pmc/articles/PMC11623110/ ↩ ↩2 ↩3